Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Introducción

prereq for everything upper case

  1. Remove the following screws securing the upper component cable bracket:
    • Remove the following screws securing the upper component cable bracket:

    • Two 2.0 mm Phillips screws

    • Three 1.4 mm Phillips screws

  2. Use tweezers to start peeling back the tape securing the upper component cable bracket. Use tweezers to start peeling back the tape securing the upper component cable bracket.
    • Use tweezers to start peeling back the tape securing the upper component cable bracket.

  3. Slowly peel the upper component cable bracket up out of the iPad—leaving the tape pieces on the bracket to make it easier to reinstall. Slowly peel the upper component cable bracket up out of the iPad—leaving the tape pieces on the bracket to make it easier to reinstall. Slowly peel the upper component cable bracket up out of the iPad—leaving the tape pieces on the bracket to make it easier to reinstall.
    • Slowly peel the upper component cable bracket up out of the iPad—leaving the tape pieces on the bracket to make it easier to reinstall.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Equipo

iFixit Miembro de iFixit

Community

134 Miembros

15,620 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 1

Todo El Tiempo: 52