Sony α6500 LCD Screen Replacement

Introducción

In order to interface with the camera and access its functions, it is important to have a working LCD screen. If your LCD screen has problems such as distortion and flickering, it may be damaged and in need of replacement. This guide will walk you through disassembling the camera and removing the LCD screen; avoid tearing the flat ribbon cables exposed in the process. When removing the screen from the plastic frame, you will break the adhesive attaching it. If desired, you may reglue the replacement screen to the frame with any super glue or epoxy. This guide requires JIS 00 and 000 screwdrivers, opening tools, a spudger, and tweezers.

Qué necesitas

Paso 1 Battery

Sony α6500 LCD Screen Replacement, Battery: paso 1, imagen 1 de 1

Verify the camera is powered off by setting the switch to OFF.

Traducir

Paso 2

Flip the camera upside down.
Slide the battery compartment lock to OPEN to unlock it.

Traducir

Paso 3

Push the blue lever aside to release the battery.

Traducir

Paso 4

Remove the released battery from the compartment.

Traducir

Paso 5 LCD Screen

Sony α6500 LCD Screen Replacement, LCD Screen: paso 5, imagen 1 de 3

Sony α6500 LCD Screen Replacement, LCD Screen: paso 5, imagen 2 de 3

Sony α6500 LCD Screen Replacement, LCD Screen: paso 5, imagen 3 de 3

To access the LCD assembly we need to remove the screws attaching its hinge to the camera body.
Remove four 3mm JIS 000 screws.
Remove one 3mm JIS 00 screw.
After dismounting the screen hinge be careful to not tear the black wire ribbon connecting the screen to the camera body.

Traducir

Paso 6

Remove the screen hinge from the camera.
Be careful to not tear the black flat cable connecting the lcd screen to the main body of the camera. This particular camera's cable has been cut for demonstration purposes.

Traducir

I would recommend removing the textured ribbon retainer at this point, as it will help with getting better access to the electronics later in the guide (you can see the ribbon retainer in the first image on step 8)

Spencer - 22 de feb. de 2024 Contestar

Paso 7

Flip the LCD screen up.
Remove two 2mm JIS 000 screws on the bottom edge.

Traducir

Paso 8

Flip the LCD screen down to access the back side.
Remove two 2mm JIS 000 screws to release the back panel of the screen.

Traducir

Paso 9

Use the opening tool to pry open the back panel.
Remove the black plastic spacer laying on top of the circuit board.

Traducir

Paso 10

Herramienta utilizada en este paso:

Tweezers

$4.99

Comprar

Carefully unplug the three wire ribbons from the circuit board with tweezers.
Likely you will need to wiggle the ribbons for a while before they come loose.
The ribbons can rip very easily, grasp the black plastic with the tweezers, on the two top ribbons, not the orange wires.