Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip the console over on its back.
-
Take note of your model number, in case replacement parts are needed.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the expansion bay by applying pressure to the small clip on the expansion bay while prying it away from the console.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate and remove all four black 12mm Phillips #02 screws from the underside of the console.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Turn the console right side up.
-
Remove the top cover by gently lifting the upper portion of the console.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the white controller cable by gently pulling the the cable while wiggling it back and forth until it detaches from the controller board.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four 14mm Philips #02 screws located on the controller board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the white fan header from the controller port.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the controller board by lifting it up from the controller port.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip the controller board on its underside so that the solder joints are exposed.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the F1 fuse by using the soldering iron and desoldering wick.
-
The F1 fuse is clearly indicated on the topside of the controller board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Insert and solder the new fuse resistor to F1 socket.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Insert and solder the parallel 10 ohm 1/4 watt resistors to the F1 socket.
-
Cancelar: No complete esta guía.
6 personas más completaron esta guía.
6 comentarios
Hello, Darren. I am having the utmost difficulty doing this with two 1/4 watt resistors, as you have demonstrated. I have three dreamcast systems, I would like to repair (all with a bad controller port.) What would be the chance that I could send you the ports, packs of resistors and and solder and pay you to do this to all of them?
I would even be willing to give you two of them! I just want one working system!
djresree -
I need this board, were do I find one?