Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unclip the clear hose from the back of the Rug Doctor.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a 7/16" (11 mm OK) wrench to hold the handle axle while you use a 7/16" socket to remove the cap nut securing the axle end.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Support the handle with one hand. It will be loose after this step.
-
Use fingers or pliers to pull out the handle axle.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Detach the handle from the Rug Doctor and set it down.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Center a sharp 3/16" drill bit on the rivet head's indentation.
-
Drill at slow to medium speed while applying steady pressure.
-
Drill about 1/3" deep—enough to drill past the rivet head and into the shaft.
-
Use a center punch and mallet to tap the shaft away from the head. Remove the rivet head.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Fully insert the stem of a 3/16" (5 mm) pop rivet into the rivet gun. The rivet gun should have a 3/16" adapter.
-
Insert the other end of the rivet into the hole.
-
Press the rivet gun firmly against the hinge plate.
-
Squeeze the rivet gun's handle completely closed. Repeat until the rivet stem breaks off.
-
Cancelar: No complete esta guía.
5 personas más completaron esta guía.