Repara tus cosas Comunidad Tienda

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Memorex CD Alarm Clock Radio PCB Board Replacement

Introducción

Removing the PCB board requires a Phillips #1 screwdriver with at least a 15 cm shaft and a set of tweezers. Make sure there are no batteries in the device and that it is not plugged in before starting the procedure.

Qué necesitas

  1. Memorex CD Alarm Clock Radio PCB Board Replacement, Memorex CD Alarm Clock Radio: paso 1, imagen 1 de 3 Memorex CD Alarm Clock Radio PCB Board Replacement, Memorex CD Alarm Clock Radio: paso 1, imagen 2 de 3 Memorex CD Alarm Clock Radio PCB Board Replacement, Memorex CD Alarm Clock Radio: paso 1, imagen 3 de 3

    • Turn the clock radio over so the bottom is facing up.

    • Pull the tab upward and remove the cover from the battery compartment.

    • Remove the batteries.

    Traducir

  2. Memorex CD Alarm Clock Radio PCB Board Replacement: paso 2, imagen 1 de 3 Memorex CD Alarm Clock Radio PCB Board Replacement: paso 2, imagen 2 de 3 Memorex CD Alarm Clock Radio PCB Board Replacement: paso 2, imagen 3 de 3

    • Remove the five screws on the bottom of the device with a screwdriver.

    • Grasp the top and bottom and gently pull apart.

    Traducir

  4. Memorex CD Alarm Clock Radio PCB Board Replacement, PCB Board: paso 3, imagen 1 de 1

    • Remove the (5) 7mm screws with a Phillips #1 screwdriver and a pair of tweezers.

    • Using a magnetic tip screwdriver will prevent screw loss.

    Traducir

  5. Memorex CD Alarm Clock Radio PCB Board Replacement: paso 4, imagen 1 de 3 Memorex CD Alarm Clock Radio PCB Board Replacement: paso 4, imagen 2 de 3 Memorex CD Alarm Clock Radio PCB Board Replacement: paso 4, imagen 3 de 3

    • Locate the wiring harness.

    • Disconnect the wiring harness using the tweezers.

    Traducir

  6. Memorex CD Alarm Clock Radio PCB Board Replacement: paso 5, imagen 1 de 1

    • Remove the PCB board from the device.

    • Replace the broken motherboard with a new PCB board.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 2

Ultimos 7 días: 2

Ultimos 30 días: 5

Todo El Tiempo: 327