Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a Phillips #00 screwdriver to remove one M2 x 3mm screw from the side of the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Swing the cover out slightly like a hinge.
-
Pull the cover directly away from the case towards the base of the laptop.
-
Lift the cover up and away from the device to remove it.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the clear tab to slide the hard drive out of the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
To replace the hard drive, remove the four M2 × 4mm wafer-headed screws on the sides of the hard drive case using a Phillips #00 screwdriver.
-
Slide the old hard drive directly out.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a Phillips #0 screwdriver to remove eight M2 × 3 mm screws near the front opening and scattered across the bottom of the laptop.
-
Remove three M2x3 mm screws using a Phillips #00 screwdriver from the base of the laptop near the opening.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the M3 x 2mm screw from the hole left by the hard drive using a Phillips #00 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Wedge the plastic opening tool between the upper and lower halves of the lower case.
-
Lift the end of the opening tool slowly until the case separates.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate and disconnect the 4 ribbon wires from the top case.
-
Locate and disconnect the two additional connecting wires.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the unattached case away from the device and place it to the side.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unscrew the two M2 x 3mm screws near the hinges using a Phillips #00 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Slide the black and grey wires out from underneath the plastic tab with the plastic opening tool.
-
Disconnect the black and grey wires connecting the screen and the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull out the fabric covered wire connecting the Screen to the motherboard underneath the cooling fan.
-