Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Introducción
Si tu altavoz ya no enciende o la calidad del sonido no es la que esperarías de un producto JBL, probablemente es necesario remplazar la batería.. Remplazar la batería le dará un nuevo ciclo de vida a tu altavoz.
Qué necesitas
-
-
Asegúrate de que tu dispositivo esté apagado antes de comenzar.
-
Separa la goma del contorno utilizando un jimmy o una espátula de metal.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the PH1 screwdriver to remove all five of the 6 mm screws from the battery cover.
-
Remove the battery cover and set the cover aside.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a spudger to carefully remove the liquid electrical tape that holds the battery inside the battery compartment.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a spudger to lift the battery out of the device.
-
Lift the end of the battery that does not have the wire connection and remove the 16 mm PH2 screw underneath the battery.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four 16 mm screws from the white plastic casing using the PH2 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Starting in a corner of the device where the casing and the side meet, use a pointed metal spudger to pry the back casing off the speaker and the glue holding the seam together.
-
Slide the metal spudger along the seam to separate the back casing from the rest of the speaker.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once the back casing is open, disconnect the three white connectors from the motherboard.
-
Remove the upper casing.
-
Para volver a ensamblar tu dispositivo, sigue estas instrucciones en orden inverso.
Para volver a ensamblar tu dispositivo, sigue estas instrucciones en orden inverso.
Cancelar: No complete esta guía.
37 personas más completaron esta guía.
Un agradecimiento especial a estos traductores:
100%
Estos traductores nos están ayudando a reparar el mundo! ¿Quieres contribuir?
Empezar a traducir ›
32 comentarios
How i replaced a new battery in myjbl reflect headphone bluetooth
Please I need directions on replacing the battery of my jbl pulse speaker because it charges but doesn't indicate battery charging nor does it work.please I will be ver grateful.
Ifeanyi(kazhbone0147@gmail.com)
I need help.
My speaker no longer takes a charge.
Not even that old
Where do I get replacement battery. And what kind
Rose -
Your instructions state to replace the white cover, but do not say why it has to be replaced. Can you expound, please? Thank you,
Hi Delton, that is a good question. The entire cover has to be replaced if one is replacing the aux/USB ports.
You can ignore that note in this battery replacement guide. Good catch!