Introducción
This guide will assist with replacing a non-functioning projector lamp, which is responsible for providing the light necessary for projection.
Qué necesitas
-
-
-
Place the projector on its back with the control buttons facing down.
-
Remove the black 7mm screw on the external case with a Phillips 2 screwdriver.
Pregunta a FixBot
-
-
-
-
Remove the 7mm screw near the bottom center with a Philips 2 screwdriver head.
-
Loosen but do not remove the 7mm screw near the upper right corner with the Phillips 2 screwdriver head.
-
-
-
Grab the silver handle.
-
Unhook the handle so it can move freely.
-
Pull the handle straight up until the lamp is completely removed from projector.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.
Equipo
Cal Poly, Team 13-17, Regan Winter 2014 Miembro de Cal Poly, Team 13-17, Regan Winter 2014
CPSU-REGAN-W14S13G17
Miembros de 6
15 Guías creadas
