Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lay the speaker flat on its back, balancing on the battery.
-
Remove the four rubber disks that cover the screws on the bottom of the speaker.
-
Follow the battery replacement guide to remove the battery
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Now, remove the four 16mm #2 screws on the bottom of the speaker. This will allow the bottom plate to be removed.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a T15 Torx screwdriver to remove the dock from the base. Be careful not to damage the ribbon during this step.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three 6mm T8 torques screws that hold the dock connector together and pull the top and bottom pieces apart.
-
-
Este paso está sin traducir. Ayuda a traducirlo
Herramienta utilizada en este paso:Tweezers$4.99-
Once the pieces are separated, the dock connector can be lifted out of the slot.
-
Using tweezers or your fingers, unplug the two ribbon connectors from the board.
-
Cancelar: No complete esta guía.
6 personas más completaron esta guía.