Introducción
This guide will be helpful for repairing the buttons in the speaker if the troubleshooting page recommends that you replace the battery. This is a necessary step when you have determined no other way to repair your current battery. Be wary of accidentally damaging other parts of the device when replacing the buttons.
Qué necesitas
-
-
Use a metal spudger to remove the mesh speaker covers (the side with the buttons) by wedging the narrow end into the center of the outer edge of the mesh, touching the red plate.
Pregunta a FixBot
-
-
-
Remove the four 5 mm screws from the red panel under the mesh using a Phillips #1 screwdriver.
-
-
-
Herramienta utilizada en este paso:Tweezers$4.99
-
If the screws are difficult to remove, use a pair of tweezers to twist and pick them out.
-
-
-
Separate the red interface plate from the black face plate by pulling them apart.
-
-
-
Push the set of buttons inward from the outside of the red plate and peel off from the inside.
-
To reassemble your device, follow these instructions in reverse order.
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.
Equipo
UMass Dartmouth, Team 8-6, Botvin Spring 2016 Miembro de UMass Dartmouth, Team 8-6, Botvin Spring 2016
UMASSD-BOTVIN-S16S8G6
Miembros de 3
8 Guías creadas
