Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
-
Utilice un Spudger para levantar el panel inferior del cuerpo. Sé sostienen con clips en el interior, por lo que tendrá que asegurarse de que se desaten durante la apertura.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a T7 Torx to remove the screws:
-
Five 5mm screws
-
Carefully flip the device upside down to remove the logic board/power supply mount.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Undo the latch connecting the power connector to the power supply.
-
Feed the wire though the logic board/power supply mount.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a T-7 Torx unscrew the two silver screws.
-
Two 4mm silver screws
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a screwdriver with a T-7 Torx bit to remove the following screws:
-
Five black 3mm screws
-
lift the power supply out of it's mount.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a T6 Torx to remove the two screws holding the power supply connector in place. Pull the power connector away from the case.
-
Two 3mm screws
-
Cancelar: No complete esta guía.
9 personas más completaron esta guía.
8 comentarios
Please, explain the 12V power supply topic: does that means it can be installed in a car or a boat out of the box?