Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Keeping it closed, turn the laptop upside down.
-
With the Phillips #0 screwdriver, remove the twelve 5 mm screws that hold the laptop together.
-
Insert the plastic opening tool between the plastic casings to pull the bottom lid of the laptop up.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the six cables that are connected to the motherboard. The cable with the white strip is located underneath the cable with the orange strip.
-
Using the plastic opening tool on one side and your fingernail on the other, wedge each cable out of its socket.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
With the Phillips #0 screwdriver, remove the two 5 mm screws that are located above the long black piece of the battery.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the two speakers for this laptop that are connected above the battery by a thin red cord.
-
Using the Phillips #0 screwdriver, remove the two 3 mm screws holding the left speaker in place.
-
Pull the left speaker up along with the red cord and leave it off to the right side.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Without bending it, lift the entire battery (both the long black piece and the rectangular blue piece) straight up. Place it off to one side.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the hard drive, which is the black rectangular object just above the battery.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the silver and yellow cable next to the hard drive up with the spudger.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Underneath the yellow cable, there is another gray and black cable.
-
Use your fingernails to pull the gray and black cable out of its connector.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull on the blue tab near the hard drive to remove the connector for the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a Phillips #0 screwdriver, remove the single 3 mm screw from the top of the hard drive sled.
-
Lift the rectangular tab to pull the hard drive out of the laptop .
-