Base Assembly Replacement
Roku Indoor Camera 360 SE (CP1000X) - Base Assembly Replacement
Introduction
This guide covers removing the base assembly from the outer housing. The base assembly is a plastic platform that contains the main board (DF3-MCU-501-V2.3), the pan motor (24BYJ48 461C), base gears, and the camera FPC connector.
Prerequisites
Complete the Back Panel Replacement guide first.
Step 1 - Squeeze the case outward
With the back panel removed, gently squeeze the outer case walls outward. The base assembly sits inside the housing held by friction and plastic clips.
Step 2 - Lift the base assembly out
Once the case walls are flexed outward, the base assembly will come loose. Carefully lift it out of the housing.
Be careful - the camera assembly is still attached via the FPC ribbon cable and mounting bracket.
Regístrate gratis en iFixit para leer el documento completo (2 páginas)
Necesitamos que te hagas una cuenta gratuita para ayudar a bloquear los bots y que iFixit siga siendo un sitio para personas.
