Before calling service

丫

Automatic Ice Maker does not work

Allow your refrigerator to operate and cool down for 24 hours (1 full day) before the ice maker starts producing ice.

To fill the ice bucket to maximum capacity, dispense a few cubes 8 and 16 hours after installation.

・

• If ICE OFF is lit, the ice maker will not make ice.

To activate the ice maker, press the ICE OFF button on the control panel so it is no longer lit.

10

• If you have the model RF268, RFG238 or RFG298, the figure may differ slightly from your refrigerator. For details, refer to the "Using the Control Panel" section of the User Manual.

Ice Off

☐ ☐ ☐

Ice Off Ice Off

丫

Slow Ice cube freezing

• Check if the ice bucket is completely inserted.

• Freezer temp may not be enough; set it to -2°F or lower.

Y

Small or bubbled ice cubes or Slow water dispensing

PUSH

If the water filter is clogged, small or bubbled ice cubes may be produced.

• Replace the water filter cartridge with a new one.

Y

Water filter replacement

• Slowly turn the water filter $ 90^{\circ} $ clockwise so it is aligned with the printing mark on the cover, locking the filter in position.

After installation or when replacing the water filter, dispense at least a gallon (2~3 minutes) of water to remove trapped air from the water line. Otherwise, water may drip after dispensing water.

Make sure to align the water filter label mark with center of cover filter printing as illustrated.

Y

Water dispenser dripping

• If the water line is not inserted into the coupler properly, air could penetrate into the water line causing water dripping from the water