SECTION III How To... SERVICE AND REPAIR

Table Caption: This table appears to be a table of contents or an index, listing various bicycle parts and components with corresponding page numbers. It covers a wide range of mechanical and electronic parts from the drive system to the console and accessories.

Page

Touch Screen Assembly ..................................................................................................... 44

Lifecycle Recumbent Bikes LC95R, LC91R, LC85R, R9, R7, 95Ri, 93Ri, 90R, and 95Re

NOTES

Lifecycle Recumbent Bikes LC95R, LC91R, LC85R, R9, R7, 95Ri, 93Ri, 90R, and 95Re How To... Replace the Side Shrouds and Crank Arms

Special Service Tools: NONE

Note: The Crank Arm Screws should not be reused more than five times.

Lifecycle Recumbent Bikes LC95R, LC91R, LC85R, R9, R7, 95Ri, 93Ri, 90R, and 95Re

How To... Remove the Drive Belt

Special Service Tools: NONE

Note: An access hole in the crank pulley allows removal or loosening of the idler bracket bolt with a socket.

1. Remove the right side shroud. See "How To…" in this section.
2. Rotate the crank pulley until the idler bracket mounting bolt is visible through the access hole in the crank pulley, then loosen the bolt.
3. Loosen the belt tension by loosening the adjusting bolt on the idler bracket.
4. Remove old belt and discard.
5. Install new belt in reverse order.
6. Adjust belt tension 100-110 lbs by moving the idler bracket down. Insert a straight blade screwdriver in the slotted lip of the bracket to obtain

specified tension. When belt tension is achieved, then tighten the mounting bolt and adjustable bracket bolt. Remove the right shroud. See "How To…" in this section.

Lifecycle Recumbent Bikes LC95R, LC91R, LC85R, R9, R7, 95Ri, 93Ri, 90R, and 95Re How To... Replace the Alternator Belt

Special Service Tools: NONE

1. Remove the side shrouds. See 'How To…' in this section.
2. Index the location of the tensioning bolt to the alternator mounting bracket, and then loosen the tensioning bolt.
3. Loosen the pivot bolt, and then rotate the alternator until the belt can be removed from the alternator pulley and the intermediate pulley.
4. Install new alternator belt in reverse order. Position the alternator belt on the far left groove of the alternator flywheel pulley (towards user side) and in the center of the alternator pulley (large pulley). Then tighten the belt back to the index mark or 70-80 lbs.

Lifecycle Recumbent Bikes LC95R, LC91R, LC85R, R9, R7, 95Ri, 93Ri, 90R, and 95Re How To... Replace the Crank Shaft Hub Assembly

Special Service Tools: Bearing Service Tool Kit - Part Number: BearingToolKit

Note: The left shroud does not require removal to service the left crank shaft hub.

1. Remove the right crank arm and shroud. See 'How To…' in this section.
2. Remove the drive belt. See 'How To…' in this section.
3. Remove the bolt and washer in the center of the hub.

NOTE: There is an arrow mark on each hub which is located 180 degrees apart,