General Equipment Hole Digger 332H/348H (2020) (RPO611)

Autor/a: iRobot (y otros 10 participantes)

Crear una guía

Yo Tengo Esto

Estudiante en Progreso

Este wiki está siendo editado por estudiantes diligentes.

Preguntas populares del foro

Haz una pregunta

No hay preguntas. ¡Sé el primero en hacer una pregunta!

Modelos

332H/348H

This model was introduced in 2020. The handles were updated to increase the balance of the machine, and reduce operator fatigue. The transmission features oversized bearings, heat-treated shafts and machine-cut gears to maximize lifespan.

This unit has a tendency to leak oil out of the transmission relief valve. The manufacturer doesn't want to acknowledge the issue and states:

"With the correct level, it is impossible for the oil to increase its volume to the point where it is can be forced out of the vent plug. In thousands of hours of testing, the oil has never been forced out of the vent plug with the correct level. The vent plug is intended to open with a 2 PSI differential and has been in use for over 30 years. "

In reality, all it takes is for the user to tilt the digger toward the relief valve while it's in use. The oil in the transmission will flow close enough to the relief valve to start leaking.

The model 332H348H hole digger requires two people to operate. It can be used for general at home landscaping, soil sampling, and other construction applications. The auger is painted orange, while the motor and handles are painted black. The identification information is located on a decal on the motor housing.

Engine
- Type: Honda GXV160, 4-stroke
- Horse Power: 5.5 HP
- Starter: Hand rewind
- Fuel: Gasoline, unleaded, automotive grade
Transmission
- Type: Totally-enclosed, grease-lubricated
  Nominal Auger Rotation Speed: 144.0 RPM, no load
- Clutch: 3.0 inch (76.2 mm) diameter all-metal automatic-centrifugal, slips on overload.
- Drive shaft Connection: .875 inch (22.2 mm) Ground Hog® Type
- Maximum Drilling Torque: 190.0 ft. lbs. (257.6 N.m.)
Auger
- Diameter: 4.0 to 18.0 inches (101.6 to 457.2 mm)
- Extension: Flighted and Non-flighted plain tube, depth to 45.0 inches (1143.0 mm)