Rep: 565
4
1
1
Hello!
I have broken my second Anywhere MX 1 mouse when replacing the SW1. The pad broke again near R6 (signal one, the ground is fine) and I was certain to not break it again. But it happened.
Is there any chance that anyone has got the schema or idea where the signal comes from? I would love to make a jumper and get my favorite mouse to work.
Es esta una buena pregunta?
Rep: 36mil
10
23
46
is this copper, can't tell with the flux
Fue útil esta respuesta?
I've edited my post and added photos of front and back. I've checked the C6, which appeared to be connected through a hole, but that side od capacitor appears to be a GND.
Nope - it is a PCB. The pad fell off. The only thing that is copper is the little hair trace that's left.
@makerbuddy have you got a multimeter
Yes I do, so I could tell that the trace goes to ground.
Besides I was working on it and today managed to catch the copper trace that was left from the pad. Used some copper wick as a new pad and everything works fine.
Besides that I still did not got idea where it goes! I've checked every component and signal points, but none of them was giving a beep in continuity test with multimeter...
Ultimas 24 horas: 1
Ultimos 7 días: 4
Ultimos 30 días: 13
Todo El Tiempo: 28
