I am trying to replace the joystick due to it sticking/stick drift; however, I cannot remove the existing solder. Does anyone have any tips or am I doing it wrong? I also believe I've burnt the circuit board but luckily this is a practice one.
Es esta una buena pregunta?
Rep: 3.4mil
12
3
3
Hi @jayshiz
I would apply flux to the solder joints and use low melt solder to mix with the existing (probably lead free) solder. It will make it easier to reflow them with a heat gun or a soldering iron.
Once you managed to get it out, clean the holes with solder wick and you'll have no problem installing the new stick.
Hope it helps!
Fue útil esta respuesta?
Ultimas 24 horas: 1
Ultimos 7 días: 34
Ultimos 30 días: 169
Todo El Tiempo: 527
