Repara tus cosas Comunidad Tienda

El Linksys WRT54G se lanzó por primera vez en diciembre de 2002. Su uso principal es compartir una conexión Ethernet entre varias computadoras.

Preguntas 2 Ver todo
Pregunta Cerrada

Opciones

worked for only 5 minutes after I did hard reset

I have a wrt54g v7 Linksys router...the problem is after supplying the power, only power led glows and rest of the led's aren't glowing...I did hard reset several times and once it worked(it was detected properly and all Led's worked fine) but only for 5 min and then returned to its initial state where only power led glows...now hard reset is also not doin any gud ..

what about changing the firmware? will it be possible to change the firmware in this condition and will it work after changing the firmware ..

any help is appreciated

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Sí No
Puntuación 0
Agregar un comentario

2 Respuestas

Filtrar por:
Mas Útiles Más Reciente Más antiguo

Opciones

You need power to flash the firmware.

Check the power adapter with a multimeter for the correct DC voltage.

If the power adapter is fine check the power jack. I'd resolder it on the mobo.

If it still doesn't worrk then you need to start tracing the power circits on the mobo.

Probably easier to pick up a used one and toss the old one.

Good luck!

Fue útil esta respuesta?

Sí No
Puntuación 0

1 comentario:

I have already checked d voltages...I used 12V 1Amp power adapter and when I checked on board using DMM ,it received proper 12v input and 3.3volts at the input of ic's

- de

Agregar un comentario

Opciones

Hi,

In this scenario i would recommend you to buy a new 4 port TP link wireless router.

As upgrading the firmware will do no good.

Good Luck.

Fue útil esta respuesta?

Sí No
Puntuación 0
Agregar un comentario
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 605