Hello
Can this be fixed? Solder does not stick, are pads gone?
I was trying to remove old solder with desoldering braid to re-tin
I can't find ribbon parts, just connectors
Need new screen ? :(
Es esta una buena pregunta?
Rep: 551
9
8
13
If that's on the screen ribbon it would be easier to buy a new screen. The cost of trying to repair that would probably equate to the price of a new screen anyway. Expensive mistake to make but you know for next time. Watch a few videos online on solder wicking.
Fue útil esta respuesta?
Rep: 4.8mil
11
5
1
in skilled hands this connector is salvageable. It takes work and experience, but it's not unusual, it just happens sometimes. For the future, consider that underestimating the temperature and breaking the pads (as in your case) or overdoing it and burning a delicate connection will take a toll on your wallet. Look for a good repair shop, it shouldn't take more than 45-60 minutes of work, and the costs... that's right. It all depends on who... where and what they can do. Sometimes it may be better to buy a new screen. The ribbon itself cannot be replaced on this screen model.
the repair technology is always the same. Rebuild the paths, protect against temperature and solder a new connector. You can find parts in the broken screens of this model. However, these are sometimes ridiculously expensive.
I can't write directly where you will find more hints, because the administrators of this forum recently launched a crusade against me, marking my publications as spam and deleting comments (apparently it's about the rules). Check out my profile, you will surely find help.
-fingers crossing,
Fue útil esta respuesta?
Ultimas 24 horas: 0
Ultimos 7 días: 3
Ultimos 30 días: 4
Todo El Tiempo: 22
