Small gap left during reassembly

One of the face buttons on my Pro Controller got gunked up and wouldn't press down the right way, so I decided to take it apart and clean it. Save for a stripped screw or two, I was able to get in, clean what was necessary, and keep everything intact. The trouble I'm running into is that the parts won't sit flush together when I try to reassemble the controller. I need to screw the faceplate and buttons back to the chassis that holds the motherboard and analog sticks, but the closest fit I can get leaves about a 2 mm gap between the faceplate and the glossy black plastic at the top. I remember having to unclip those two parts, so to speak, when I took it all apart, but I can't for the life of me figure out how to clip them back the right way. Any advice on how to maneuver everything?

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0
Agregar un comentario