Saltar al contenido principal

El iPhone 5s de Apple fue anunciado el 10 de Septiembre, 2013. La reparación de este dispositivo es similar a los modelos anteriores y requiere destornilladores y herramientas de palanca. Disponible como GSM o CDMA /16, 32, o 64 GB / Plata, Oro, y Gris Espacial.

Preguntas 3530 Ver todo

iPhone 5s battery replace issues

Hello i replaced my iphone 5s battery but when start my phone battery charge status 1% when i recharge battery its jump and stuck on 27% percent

After i shutdown my phone and on it Again battery comes on 1% again are there any solutions

Also my phone randomly rebooting after 2-3 minutes

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0
1 comentario

where did you get the battery from?

- de

Agregar un comentario

2 Respuestas

Respuesta Más Útil

So you make Battery BSI track open. See around the battery connector you can see some parts are missing. If the coil is missing simply jumper it and enjoy.

Fue útil esta respuesta?

Puntuación 1

1 comentario:

Please explain more i not understand what you are mean

- de

Agregar un comentario

The symptoms your iPhone have is most likely caused by a damage logic board. Take a good look at the logic board around where the battery connector is, it is possible that you have knock of a small component of the logic board when you have replaced the battery. You might need a magnifier or microscope to see it, at the place where component is missing you can make a jumper between the two pads. Sorry for my poor English but I hope you understand what I try to explaine.

see this for example: https://youtu.be/Q4fIp9vgsB8

Fue útil esta respuesta?

Puntuación 0

2 comentarios:

Hey

Unfortunately i not have  microscope but if there's any missing  part around  battery  socket are that component repairable?

And are you think maybe  the new  battery  have a problem  i am so scared  about component if they  missing

Sorry  for  my poor  English

- de

I think the problem is in a missing component around the battery connector, take a magnifier and take a look, it isn’t that difficult to make a jumper, I use silver conductive glue to make this jumper. Much easier then with micro solderen.

- de

Agregar un comentario

Añadir tu respuesta

Abdurrahman Najdi estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 7

Ultimos 30 días: 12

Todo El Tiempo: 82