Troy built pony will start when jumping the solenoid but not with key.

I put in a new starter solenoid, and ignition key. I tried jumping the two wires from the solenoid to the ignition and no luck. I checked the safety switches and the three look ok. I bench tested the solenoid and when I put power to it it clicks.

1) how do I bypass the safety switches completely, not zip tie them. 2)Are they breaking a circuit or completing one?

Again when I jump the solonid it turns over just not with the key… help

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0

1 comentario:

In my experience most of them are completing a circuit. but I have seen it the opposite in some cases depends on manufacture.

- de

Agregar un comentario