Hello, I just replaced my screen and digitizer of my Ipad 6th Gen. But now only some parts of the screen are working. Is there a fix for this or send my screen back for another one.
Es esta una buena pregunta?
Rep: 4.8mil
11
5
1
Hello Tyson,
In this model, the digitizer is an independent system. Unfortunately, it is led with quite long tapes with a non-grounded signal. During installation, remember that the tape circuits provided for earthing must be glued through the conductive layer in designated places. Otherwise, it causes uncontrolled short circuits to ground or the signal does not reach the motherboard at all. Another (indirect) reason is too strong bending of the connection tapes and, as a result, breaking the continuity or being trapped by the screen.
You'll have to unfold it again and check your work. Alternatively, you can use an experienced repair shop.
Fue útil esta respuesta?
I don’t understand the “earthing” cable part
Bob - it mens "grounded" :) (slang)
Ultimas 24 horas: 1
Ultimos 7 días: 3
Ultimos 30 días: 9
Todo El Tiempo: 54
