Error code 00008 in display - where to look for

Question

MiJia QiCycle Folding Electric Bike

The QiCycle Folding Electric Bike is Xiaomi’s first foray into the world of e-bikes. It has a 250W high-speed motor powered by Panasonic 18650 lithium batteries. The Shimano Nexus 3-speed gear hub in combination with the torque measurement sensor gives you up to 45km bike power on a single charge. It also has a trip computer can connect to your smartphones via their special app and is–of course–foldable.

Preguntas 54 Ver todo

Frans Dijkstra @franssie

Rep: 13

2

1

Publicado: 19 de abr. de 2021

Opciones

Error code 00008 in display - where to look for

Just after a few days usage the bike shows an error when I start the computerdisplay.

I suspect a sensor/cable not working but without repair manual it is hard to know where to start. The owners manual does not mention any error codes?

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Sí No

Puntuación 0

Agregar un comentario

3 Respuestas

Solución Elegida

Frans Dijkstra @franssie

Rep: 13

2

1

Publicado: 24 de jul. de 2021

Opciones

No unfortunately. I had to send it back to the seller and they could not figure out…so they refunded me. I loved the bike so might buy another of I can find a seller that does service the bikes.

Fue útil esta respuesta?

Sí No

Puntuación 0

1 comentario:

Well, I had two bikes and the second bike gave the same error an I solved it: Is is the engine disconnected error.

What happened is that the steer and frontwheel were turned backwards and that put stress on the engine connector, and it csme loose. It is located inside the left stem of the fork, you can see it if you look from the right side in.

I had to remove a little clamp and was able to rejoin the connectors and the error dissapreared. In stead of putting the clamp back, I used two tiewraps to fix the cable on the stem so I can easily remove the tiewraps and reach it when I am not at home.

27 de jul. de 2022 - de Frans Dijkstra

Agregar un comentario

Well, I had two bikes and the second bike gave the same error an I solved it: Is is the engine disconnected error.

What happened is that the steer and frontwheel were turned backwards and that put stress on the engine connector, and it csme loose. It is located inside the left stem of the fork, you can see it if you look from the right side in.

I had to remove a little clamp and was able to rejoin the connectors and the error dissapreared. In stead of putting the clamp back, I used two tiewraps to fix the cable on the stem so I can easily remove the tiewraps and reach it when I am not at home. — Frans Dijkstra