Saltar al contenido principal

Repara tus cosas

Derecho a reparar


Lanzamiento el 21 de septiembre de 2018. Modelos A1920, A2097, A2098, A2100. Disponible como GSM o CDMA/eSIM o nano-SIM/64, 256, o 512 GB/ Plateado, Dorado o Gris Espacial (Pronunciado "iPhone 10 S.")

Preguntas 186 Ver todo

iPhone XS laging and restarting after 3mn


I did a back glass replacement and after reassembling the phone. It is laging. I tried to do some troubleshooting

1- when i disconnect the back and front camera the phone works well with no lag

2- when i connect only the back camera the phone lags ( the camera is work but not a the first attempt )

3- when i connect only the front camera the phone lags ( and face id says “face not visible” )

4- when i connected both cameras, phone lags ( both cameras are working, but the flash doesnt )

5- For the restarting issue i think i damaged the charging port while removing the back glass. I read that in another forum

Please help. I dont know what else to do

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0
Agregar un comentario

2 Respuestas

Solución Elegida

Back Glass or Whole Housing replacements can suffer from the same issues, mainly damaged flexes or connectors. If the phone works fine without the cameras, then closely examine the camera flexes and connectors (and the equivalent connectors on the logic board.

Look for tears in the flexes, even the tiniest ones. Sometimes the connector pins get damaged or some surrounding components can be fully or partially dislodged. All of this inspection may require some magnification.

EDIT 2020-10-26

Take a closer at this flex, based on your picture below (

Block Image

Fue útil esta respuesta?

Puntuación 2


I doublechecked the connectors and the flexs but i haven´t seen any damages. These are some macroshoots i took, maybe there can be helpful.

What about the restart after 3minutes ? Is It the Charging port which needs to be replaced ?

- de

I double checked the flex but it is not damaged. i took a better picture

- de

Agregar un comentario

Hello Michel,

While the phone is on connect it to your pc run CoconutBattery app:

If the design capacity shows value around 100mAh (normal value would be the thousands range ~2000-2658mAh)it would suggest you damaged either the battery connector or a tiny component around the connector. If that’s the case you would need a professional to fix it. It would help if you cold post pictures of the battery connector in question.

Fue útil esta respuesta?

Puntuación 0


Heloo Roman,

thank for your response. I don´t have a Mac but a Windows PC. I used 3UTools to check the Ah. It shows 2642mAh as designed capacity.

These are some pictures.

- de

Agregar un comentario

Añadir tu respuesta

Michel Ngne estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 3

Ultimos 30 días: 13

Todo El Tiempo: 88