Saltar al contenido principal

A general-purpose audio device that transmits low audio frequencies to your ears.

Preguntas 20 Ver todo

Only 1 amp working!

I have 2 amps set up everything is wired up good I checked all my volts with a multimeter ,and everything checks out . But it seems that I can only have 1 amp wired to get any power . I wired each of my amps to 1 power source and each amp started up so is there a reason I can’t set up my highs amp and my bass amp ?

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0

Comentarios:

@jaimeibarra what make and model are your amps. How did you wire them up? Schematic or picture?

- de

Agregar un comentario

1 Respuesta

Respuesta Más Útil

There might be an issue with the remote turn-on lead. Some radios don’t provide enough current out of the remote lead to turn on multiple amps. Try running 12V from the battery to both of the amps remote turn-on leads and see if they both turn on. If that works, then you can use a relay connected to the radio’s remote turn-on lead and switched 12V power to switch your amps on. Also check to see if you get a voltage drop when both amps turn on at once. It’s possible that one of the amps is going into protection mode due to under-voltage. There could be a wiring, car battery, or alternator problem that isn’t supplying enough current for all your car’s electronics.

Fue útil esta respuesta?

Puntuación 1
Agregar un comentario

Añadir tu respuesta

Jaime Ibarra estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 38