Saltar al contenido principal

La consola de juegos Xbox de tercera generación de Microsoft, lanzada el 22 de noviembre de 2013.

Preguntas 637 Ver todo

XBox One Schematics diagrams

I need help identifying 2 resistor values near the HDMI ports. Any help would be greatly appreciated. Thanks in advance for your help.

Update (04/08/2019)

Here are some pictures

Block Image

Block Image

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0

Comentarios:

Not sure those uploaded or not

- de

I attempted to post some pictures for you. I don't think it worked. Anyways, I hope my description was helpful.

- de

Don't see them. can you upload them to imgurl or tiny upload and post link? I got the board in front of me there is quite a few resistors there

- de

I will see if I can post a new question with pictures.

It just says Image. I don't think it's going to let me.

- de

I posted a new question tilted "need help identifying 2 resistor values" you my need to scroll down to see the pictures.

- de

Mostrar 2 comentarios más

Agregar un comentario

2 Respuestas

Solución Elegida


I just took measurements from a board I'm working on, the resistors read 2K (2,000) ohms on my meter. Hope this helps, size might be 01005.

Fue útil esta respuesta?

Puntuación 0

Comentarios:

Thank you very much for your help and time.

- de

You are welcome.

- de

Agregar un comentario

Can I ask you why you are looking for these two resistor values? What’s the issue with your Xbox?

can you provide a picture of which ones exactly I could probably get you the values since my Xbox one is torn open currently.. as I’m trying to fix a turning on issue.

Fue útil esta respuesta?

Puntuación 0

Comentarios:

When trying to get the HDMI jack out, I heated the board up to do so. Whish I had a pre-heater and a nice hot air soldering machine. Hence why I should of waited till I got back to work where I have these tools available. I'm out from surgery though. Anyways, to make a long story short these 2 resistors fell off the board. The resistors are labeled R1M2 (bottom of board near HDMI out jack) and the other is R8A4 ( I believe this one was green in color on top side of PCB near HDMI in, close to the pins of the port) I was swapping out the HDMI in for the out. Real pain in the butt without the proper tools. I really appreciate your help so much. Thank you

- de

Agregar un comentario

Añadir tu respuesta

chris wilcox estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 25

Ultimos 30 días: 168

Todo El Tiempo: 7,660