Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Un vaporizador de cigarrillo electrónico es una alternativa reutilizable al tabaquismo tradicional.

Preguntas 105 Ver todo

Smok x-priv bricked, turns on to show smok logo and cuts out

hi all i have a Smok x-priv mod donated from a friend it started with a short in the atomizer error so i cleaned the port for the tank and checked the batteries etc, i then plugged it into my laptop to charge, as soon as i plugged it in it went to a black screen and would not turn on, the only way i can get any activity is by taking out the batteries and putting them back in, this brings up the smok logo and then it shuts down, does anyone have the firmware for this device so i may try reinstalling it, i have tried the method mentioned in another post saying to hold down all buttons without batteries, and to connect to a pc then put the batteries in but this did nothing

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 1

Comentarios:

also any info on how to remove the firmware from my bricked device would be appreciated thanks peeps, cant seem to find it when i connect it to my pc

- de

mam ten sam problem przy xpriv baby

- de

Agregar un comentario

SALTEA LA ACTUALIZACIÓN

Ahorra reparando con un kit todo en uno.

Compra Kits de Reparación

SALTEA LA ACTUALIZACIÓN

Ahorra reparando con un kit todo en uno.

Compra Kits de Reparación

3 Respuestas

Respuesta Más Útil

Sounds like it’s just not charged. Have you tried changing the batteries for known good fully charged ones?

Fue útil esta respuesta?

Puntuación 1
Agregar un comentario

I just had to run to my local vape shop as i was having the same issue it took me and the owner a few minutes to figure it out.

If you know how the locking on this device works you have to do that after you put in the batteries. After the smok logo disappears just tap the firing button five times not to fast or slow and then wait a second it should show the smok logo again and then then screen will show all the info and be ready to fire. it’s not software it’s user error and man you’re not alone.

Fue útil esta respuesta?

Puntuación 1

Comentarios:

For me not working but I have the same issue the logo shows when I put batter's but not screen with info. Thanks, if you have another solution I would by happy to hear it.

- de

Agregar un comentario

This may be a very late reply but I had the same issue and I was very concerned.


To fix I inserted the charging cable, the charging screen popped up and then I pressed the firing trigger 5 times.


All fixed now.

Fue útil esta respuesta?

Puntuación 1
Agregar un comentario

Añadir tu respuesta

Tom Norc estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 5

Ultimos 7 días: 24

Ultimos 30 días: 96

Todo El Tiempo: 4,042