Repara tus cosas Comunidad Tienda

Nintendo Switch es una videoconsola portátil a la que se puede jugar en el televisor a través de una estación de acoplamiento, o sobre la marcha. Sale a la venta el 3 de marzo de 2017.

Preguntas 704 Ver todo

Opciones

Nintendo Switch LCD screen seems loose after digitizer replacement.

I recently replaced my digitizer (I know, stupid idea, whatever) and all seemed to go well for the most part until I put it back together and the LCD screen jiggled around underneath. I took the digitizer off and could tell it was obviously the LCD screen, but I don't even know what holds it in place. The ONE video online mentions it, but doesn't really explain what he does about it. Is this supposed to be like this. If not, how can I fix it?

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Sí No
Puntuación 0
Agregar un comentario

3 Respuestas

Filtrar por:
Mas Útiles Más Reciente Más antiguo
Solución Elegida

Opciones

Hi! The LCD is normally held in place by pressure from the digitizer and the screws holding the rest of the console together. You'll want to make sure that the digitizer is held in place firmly with adhesive. Also, if you didn't clean off the old adhesive on the frame and the new digitizer had adhesive on it then you have two layers of adhesive. That would be enough to cause it to move around in there.

Hope this helps.

Also, I'm not sure if you've seen my teardown on this but here it is just in case:

Fue útil esta respuesta?

Sí No
Puntuación 3
Agregar un comentario

Opciones

I replaced mine too and it does this but I’ve already stuck the new digitizer down so I don’t wanna take it back off to try and secure the lcd with more adhesive as it is really hard to find the perfect spot for the lcd to stay so that you have even borders all the way around anyway. Might get aggravated and try it anyway in the future though.

Fue útil esta respuesta?

Sí No
Puntuación 0
Agregar un comentario

Opciones

Hey. A little late, but the old digitizer has a thick rubbery frame that surrounds the LCD, and that's what holds it in place. It's not the screws because they don't clamp on the digitizer. If you still have the old one, carefully remove the rubber piece and stick it on the new digitizer. Make sure the LCD is square with the rest of the system before putting the digitizer down, or it'll be slightly tilted which would drive me bananas

Fue útil esta respuesta?

Sí No
Puntuación 0
Agregar un comentario

Añadir tu respuesta

jordandr estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 7

Ultimos 30 días: 17

Todo El Tiempo: 3,141