Repara tus cosas Comunidad Tienda

Lanzado el 21 de julio de 2011. Procesador Core i5 o Core i7. Rayo. Esta unidad también se utiliza para ejecutar la configuración de Mac mini Server.

Preguntas 204 Ver todo

Opciones

Power Button Wiring Mac Mini 2011

Got a Mac Mini in for the fan connector replacement which has been replaced, however the wires going into the power button from the logic board have been pulled off by the customer when fitting the dual hard drive enclosure.

I'd like to strip and resolder the wires to the power button PCB, but could anyone confirm which wire goes where (black and a grey one), since I haven't got another one to hand, and it's possible they are in the wrong position.

Thanks.

Block Image

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Sí No
Puntuación 1
Agregar un comentario

1 Respuesta

Filtrar por:
Mas Útiles Más Reciente Más antiguo
Solución Elegida

Opciones

I don't think it matters, which goes on what side.

Double check using a Ohm meter to see if one side of the button contacts is chassis ground, if neither are it makes no difference.

Fue útil esta respuesta?

Sí No
Puntuación 2

3 comentarios:

Thanks, I'll check once I'm in again on Saturday. I'm sure it said something like 'PWR1' and 'PWR2', but I only saw this when I peeled back the tape to see the wires were damaged, so I'm probably wrong

- de

Its a soft switch - Momentarily contact blister switch, which is sensed within the power supply to kick the power supply on. Just like the iMac's

- de

Thanks. Grey wire (gnd) goes on the left side and the black wire on the right side. Works fine now :)

- de

Agregar un comentario

Añadir tu respuesta

Reece estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 7

Todo El Tiempo: 983