Hello,
after I replaced the broken display of my PowerShot SX610 and putting the camera together again, it doesnt start anymore. Is there a hidden switch, which I have to push after the camera was open? And if yes, where is it located?
Thanks for your help and sorry for my bad english.
Regards Florian
Es esta una buena pregunta?
I am having the same trouble right now
Any one with any idea?
Fue útil esta respuesta?
Rep: 1.3mil
15
4
2
Hello,
it is not easy to give an answer to this. As far as I know there are no hidden switches. If you only replaced the screen, there could be a problem with a power connector. Try disassambling the device, reassamble it again and check every single connector you opened. Are any flatcables upside down? Every flatcable pushed in place? Probably a broken cable (most times you can see this)?
Good luck, John
Fue útil esta respuesta?
Ultimas 24 horas: 0
Ultimos 7 días: 0
Ultimos 30 días: 0
Todo El Tiempo: 62
