Saltar al contenido principal

Procesador G3 modelo M8413 o A1007 / 600, 700, 800 o 900 MHz

Preguntas 36 Ver todo

Battery will not fully charge

Have a iBook G3 900mhz 14 inch. Was working fine, but the battery gave out. I replaced the battery with a cheapie from ebay. The battery would only charge for a few minutes, then my charger would glow to green, even if the battery was not fully charged.

I reset my PMU and it would charge again for a few minutes, but then it would stop charging. If I keep re-setting the PMU, I can fully charge the battery and the iBook runs fine on the battery.

I thought it could be the DC in, so I replaced it, but same problem. Is this likely a problem with the battery of with the logic board. I do not want to spend more on another battery if that is not the problem.

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0
Agregar un comentario

2 Respuestas

Solución Elegida

Download and run Coconut battery to see what you got on eBay and the condition of it. http://www.coconut-flavour.com/coconutba...

Fue útil esta respuesta?

Puntuación 2

5 comentarios:

Thanks, downloaded coconut, says current battery charge is 94% capacity is 4400 mAh. battery-loadcycles 10. charger is connected and the battery is NOT charging.

As I said, I was only able to charge the battery by resetting the PMU many times. If I run down the battery, it will not charge unless I reset the PMU. After that it will recharge for a few minutes, then stop charging, adding only a few percent at a time to the battery capacity. Do you think this is a battery issue or something else?

Thanks for your help!

- de

Will the machine run without the battery in? What are the last three letters of your serial number?

- de

Yes, the machine will run plugged in (of course), with out the battery. My serial number ends in …RPF3

- de

Here's your machine:

Apple iBook G3/900 14-Inch (Early 2003 - Op) Specs

Identifiers: iBook - Early 2003 - M9009LL/A - PowerBook4,3 - A1007 - N/A

I would replace the battery connector, it's under $10: [producto vinculado inexistente o deshabilitado: IF151-017]

- de

I will give that a try, will let you know if that does it.

thanks!

- de

Agregar un comentario

You can try calibrating the battery by working on battery power (not plugged in) until it's copletely dead. Than recharge. Repeat the cycle a couple of times. This sometimes help, especially with third party batteries.

Fue útil esta respuesta?

Puntuación 0

1 comentario:

Thanks, I will give that a try, but since the battery stops charging and only shows that is partially charged until I reset the PMU and start charging again, I do not think it's a calibration issue. I would assume that if it were a calibration issue, then the battery would say it was 100% charged when it was not. If I reset the PMU enough times to fully recharge the battery, I believe that the battery is fully charged. What I am trying to determine if the problem lies with the battery or the logic board.

- de

Agregar un comentario

Añadir tu respuesta

studio58 estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 10

Todo El Tiempo: 1,249