Rep: 1.6mil
12
5
3
Customer brought in an iPad Pro 12.9" with a cracked screen. I replace the screen and soldered the new one on properly 100%. Customer has issues with the dead spot on the screen. So I ordered a brand-new digitizer assembly and install that one. Exact same issue as the first one. Anybody have any suggestions? No apparent damage to the control board and soldering is good. Thanks!
Es esta una buena pregunta?
Rep: 1
1
then the controller board is bad, simple
sounds to me like proccess of elimination its the controller board, too much heat, etc can damage a controller board, hope you find a solution.
Fue útil esta respuesta?
Rep: 61
3
lcd is not ok failure
Fue útil esta respuesta?
LCD is perfectly fine on both. Ordered from 2 separate manufacturers, dead spot in same exact area.
Ultimas 24 horas: 0
Ultimos 7 días: 4
Ultimos 30 días: 12
Todo El Tiempo: 486
Same supplier? Seconds?
- de mayer
Different Supplier. LCD is good on both.
- de GadgetERService