Saltar al contenido principal

Support for gas-powered and electric golf carts, sometimes referred to as golf cars or club cars after the Club Car Golf Cart brand.

Preguntas 493 Ver todo

No reverse on my golf cart

My electric golf cart lost its reverse can I fix it myself or do I have to take it in to a service center?

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 7
9 comentarios

Would you give us your model number?

- de

EZGO textron serial number 833198

- de

@gerryr and the make of your cart as well :-)

- de

I find nothing but EZ-GO on the cart

- de

Okay lets get to work. Based on your serial number you have a :

Make: Medalist

Type: Electric 36 V

Model: Electric Medalist

Year: 1994

Sounds about right?

- de

Mostrar 4 comentarios más

Agregar un comentario

2 Respuestas

Solución Elegida

@gerryr, this could be as simple as the reverse switch being the problem. It is a mechanical contact and could be not making the connection. You can check that by switching the wires from the forward/reverse switch and see if you now have only reverse. If so, you know it's the switch. You did not tell us if your cart has a backup beeper and if it still comes on. Also, let us know if this cart has a dash mounted toggle switch.

Block Image

Fue útil esta respuesta?

Puntuación 9

9 comentarios:

2008 yamaha cart with back up buzzer

- de

what if its not the switch?

- de

I replaced the forward reverse control board. Now I have no reverse. Reverse worked prior to replacing control board.

- de

@mikegolf have you tried to switch the wires to see if you then have reverse but no forward?

- de

Hi my ez-go 2005 txt cart suddenly decided to not go in reverse ! the reverse alarm sounds but the cart won't go ! it will run forward when I push on the rocker switch. I checked the contacts behind the switch and they are ok no broken or frayed wires.

- de

Mostrar 4 comentarios más

Agregar un comentario

mine was the micro switch on the passenger side of the forward reverse switch. I just bent the prong put on the lower side of the metal just below the white tip of the switch. This way it pushes further into the switch housing.

Fue útil esta respuesta?

Puntuación 2
Agregar un comentario

Añadir tu respuesta

gerry estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 19

Ultimos 7 días: 124

Ultimos 30 días: 557

Todo El Tiempo: 56,182