Rep: 37
2
1
When you pull the trigger the drill only runs a short time and stops. Releasing the trigger and re-pulling it does nothing. If you release the trigger and switch direction, then pull the trigger it run but again only for a few seconds.
Es esta una buena pregunta?
Rep: 103
3
Battery is most likely dead. Try charging it,........ . Test it using a multimeter. The batteries can go bad and they will no longer accept a charge.
Fue útil esta respuesta?
The battery can be easily tested using a multimeter ,check voltage before charging, then fully charge the battery , then check to see if it has correct voltage after charging,
This is not very helpful ,the batteries are fully charged and the batteries work fine in other Ryobi tools.
Mark Day, yeah i absolutely right with you ,
My problem is with a cordless drill 18V ..
Its worked for a few seconds atleast 3 or 5 second then become off but the battery are fully fine
Ultimas 24 horas: 4
Ultimos 7 días: 15
Ultimos 30 días: 78
Todo El Tiempo: 9,888
Hi I have the same problem.I'm thinking bushes.I'll look later and let u know bro
- de Kurt Feehan