Saltar al contenido principal

Cobra 29 LTD Classic. 2-way 40 channel CB radio. Features antenna warning indicator, SWR calibration, instant Channel 9, PA capability, dimmer control, switchable noise blanker and RF gain.

Preguntas 8 Ver todo

My rx/tx light turns red

When I key my mic the rx/tx light turns red. When I unkey it turns back green. I also cannot recieve anything coming in nor can I get out. Please let me know what you think

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 5
1 comentario

Mine does the same thing but no antenna light

- de

Agregar un comentario

6 Respuestas

Respuesta Más Útil

Your tx/rx light should turn red when you transmit and be green all other times. Your ant light should not light up unless the swr is higher than 3.0; then there is a problem. A common reason for the ant light to light up is that the antenna is not grounded properly.

Check out this page from Firestik for more information on swr and cb's.

If your ant light is on when you transmit, stop using the radio and fix the swr. You will ruin the radio.

Good luck and enjoy your cb radio!

Fue útil esta respuesta?

Puntuación 2

1 comentario:

the green light is suppose to be on whe cb is turned on .and red when keyed up.

- de

Agregar un comentario

first thing first, check the antenna RF cable

Fue útil esta respuesta?

Puntuación 0

1 comentario:

Mine does the same thing but my ant does not light up when i key the mic.

- de

Agregar un comentario

My RX/TX turns red when I transmit as expected, Have no problem transmitting or receiving, My SWR as Advertised and Antenna light stays off, RX/RT light is green until transmit, Make sure that NB-ANL/ANL OFF

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

From what I was reading the NB-ANL/ANL help filter out the noise from the ignition system and other working parts of the vehicle that give off background noise. So, why do I turn this off??

Fue útil esta respuesta?

Puntuación 0

1 comentario:

I wouldn’t turn off the NB/ANL. It filters out a lot of noise.

- de

Agregar un comentario

Ok sorry don't have an answer I have another question, my rx/tx red when I key up like it's supposed to, but I have mine on cal to calibrate it but the needle doesn't move to cal ... it doesn't move at all for that matter ... what gives !!?

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

To calibrate it you have to have it on ch 1 and ch 40

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Añadir tu respuesta

Jake Harris estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 13

Ultimos 7 días: 122

Ultimos 30 días: 600

Todo El Tiempo: 40,650