Repara tus cosas Comunidad Tienda

Lanzado en junio de 2012 / Procesador Core i7 con Turbo Boost / Hasta 1 GB de RAM de video DDR5

Preguntas 597 Ver todo

Opciones

Solder line in port on audio port's place

Block Image

Block Image

Hello,

A headphone tip broke off in my audioport, and after reading terrible advice on some forums I tried the superglue idea to remove the tip.. Resulted in my port being glued together.

Long story short, I found a company who thought it would fix my internal speakers if the audio port was removed from the Logic Board. Guess what, it didn't. It seems impossible to get a replacement part for the audiojack as well.

Now, is it possible to desolder the Line-In port and solder it on the audio port's place in order to fix my internal speakers?

I don't need the headphone jack to work persé, I just want my internal speakers to come back to life.

Greetings,

Marc

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Sí No
Puntuación 2
Agregar un comentario

1 Respuesta

Filtrar por:
Mas Útiles Más Reciente Más antiguo
Solución Elegida

Opciones

schoutenmj, the Line In jack and the Audio Jack are different. Apple part number for the Line in jack is 514-0635 and the Audio Jack is 514-0671. Sure you could always try, but the biggest issues is that you may run into trouble soldering it twice and trying to make it fit. More room for error. If you do want to replace it, you can try and find a new jack or you can get it of an old board. The issue here is that it will require quite some skill to solder it properly. Take a look at the schematic. Pin 1 and pin 2 are normally closed, and open when you insert the jack. So if you remove the jack, your circuit will be open. Try to place a jumper from pin 1 to 2 to close that circuit.

Block Image

Fue útil esta respuesta?

Sí No
Puntuación 3

3 comentarios:

Thanks for your reply, Oldturkey03!

Unfortunately, I'm not able to read schematics as I'm a total noob in soldering, but perhaps I can try to find someone who can and place that jumper you were talking about to close the circuit and make the speakers come to life!

- de

Post an image of your logic board with your question. focus on the area where the audio jack was located. Post front and back images so we can show you at least where pin 1 and 2 are located. to add images to your question, use this guide Agregar imágenes a una pregunta existente

- de

I'm not so fond of taking out my logic board myself, I'm not really handy with these small electronics (stuff will break if I touch it..!!)

So I guess I'll just have to find someone who won't and can solder it for me. :P

Thanks for your time and effort, Oldturkey03!

EDIT: I've posted some pictures of the backside, one with dramatically overflash but the holes in my logic board are properly visible there.

- de

Agregar un comentario

Añadir tu respuesta

schoutenmj estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 3

Ultimos 30 días: 7

Todo El Tiempo: 212