Saltar al contenido principal

Model M8413 or A1007 / 600, 700, 800, or 900 MHz G3 processor

Preguntas 42 Ver todo

Do I need to replace the yellow foam on the Video BGA?

I am reinstalling my logic board after a reballing repair. I sent the board in with the yellow foam pad attached to the shield side of the BGA. It was returned without it. How important is that pad? Is it an insulator or heat conductor? the only thing that would come into contact with it would be the lower shield.

Thanks,

Randy

Contestado! View the answer Yo también tengo este problema

Es esta una buena pregunta?

Calificación 0
Agregar un comentario

Kits de Reparación de Batería de iPhone

Sólo $29.99

Buy Now

Kits de Reparación de Batería de iPhone

Sólo $29.99

Buy Now

1 Respuesta

Solución Elegida

Foam pads are normally just isolation devices, intended to either act as a cushion or to separate parts that could make contact with each other. I'd replace it with something similar but I'm not sure it's totally necessary.

Fue útil esta respuesta?

Calificación 1

Comentarios:

Thanks Bob,

I had received an answer to this question on Apple Discussions from a member who said it was a thermal pad. That didn't seem right to me, but I replaced the yellow pad with a blue Apple thermal pad from another iBook an a couple of layers of thin thermal pads from Radio Shack.

From what you're saying, it sounds like I haven't done any damage. Maybe the iBook is even running cooler because of it. Who knows.

Thanks for your reply,

Randy

por

Agregar un comentario

Añadir tu respuesta

randy3833 estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 1,130