Repara tus cosas Comunidad Tienda

El iPhone 5c de Apple fue anunciado el 10 de septiembre de 2013. La reparación de este dispositivo es similar a los modelos anteriores, y requiere destornilladores y herramientas de entrometimiento. Disponible como GSM o CDMA / 8, 16, 32 GB / Blanco, Rosa, Amarillo, Azul y Verde

Preguntas 1233 Ver todo
Pregunta Cerrada

Opciones

Digitizer not responding after replacing with working screen/digitizer

Hi peeps,

I have received one iphone 5c which powers up, but doesn't respond when swiping to unlock.

I have another iphone 5c that has a working screen/digitizer, so I've taken this and replaced it with the non-responsive one. Same issue occurs - can't swipe to unlock.

Does anyone have any idea as to what could be causing this? Could it be a duff connector on the main board?

I'm pretty sure the phone may have been water damaged.

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Sí No
Puntuación 0

1 comentario:

Anyone?... Anyone?... Bueller?

- de

Agregar un comentario

3 Respuestas

Filtrar por:
Mas Útiles Más Reciente Más antiguo

Opciones

It is likely a board level issue, maybe a short or an issue with the U3. The digitizer connector would usually still allow the touchscreen to have limited responsiveness.

Fue útil esta respuesta?

Sí No
Puntuación 0
Agregar un comentario

Opciones

Dave C , this can be caused by a bad digitizer connector. As you can see the connector lacks metal ends and this is what makes it a weak connector. It is easily possible to damage the connector by mis-aligning the digitizer connector

Block Image

Block Image

like this. Check the ends of the connector. The plastic of the connector has been compressed into the connector, causing it to flare out and preventing from making proper contact.

Fue útil esta respuesta?

Sí No
Puntuación 0
Agregar un comentario

Opciones

I ended up fixing this in the end.

All it needed was a couple of minutes in the ultrasonic cleaner and and good brush with IPA.

I'm pretty sure it was the contacts on the board that were the problem.

Thanks for your suggestions

Fue útil esta respuesta?

Sí No
Puntuación 0
Agregar un comentario
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 151