Saltar al contenido principal

La Baby Lock Ellegante 2 es una versión compacta de una máquina de bordado industrial, producida por Baby Lock.

Preguntas 16 Ver todo

Using the extra large hoop

When trying to use the extra large hoop I keep getting a message to change to the extra large hoop and I already have that one attached. What can I do to make the machine recognize that I have the correct hoop?

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 1

1 comentario:

My machine does automatically select the hoop size in Edit mode and I verified the largest hoop was selected. I also make sure the design fits nicely with room to spare. I think something is wrong with my Embroidery unit that attaches to my machine because yesterday I was trying a design (in the mid size hoop) and the lettering did not sew in place...it went uphill. So I"m off to the shop with it. Thanks so much for your suggestions.

- de

Agregar un comentario

1 Respuesta

Did you go to settings and tell your machine what size hoop you are using? The machine does not know what size you have attached unless you tell it. If you get too close or past the allowed area you will get the signal to change to a bigger hoop. Since I am new at machine embroidery I try to make my design just a bit smaller than the maximum allowed size to avoid this message.

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Añadir tu respuesta

Jean Berch estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 15

Todo El Tiempo: 580