I tried to uninstall the drive gear on the bullet blender. The screw in the base won't hold a screwdriver and the gear is too tight to get it off as the driver slips in the slot. Would like to know if anyone has a better technique to take it off for replacement.
Es esta una buena pregunta?
Rep: 782.4mil
1.1mil
893
2.3mil
Nick Steffen, I hear you. That was a bear to take it. You can disassemble the blender leaving the gear on. Then place the stator in a vise at the end where the slot for the screwdriver is. Use a pair of good channel lock or vise grips to take the gear of. It is easily possible that you will destroy the gear. Make sure you have replacements.
Fue útil esta respuesta?
Ultimas 24 horas: 0
Ultimos 7 días: 0
Ultimos 30 días: 0
Todo El Tiempo: 63
