Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Tercera generación de iPad con Wi-Fi, lanzado el 16 de marzo de 2012. Número de modelo A1416. La reparación requiere calentamiento y palanca cuidadosa.

Preguntas 194 Ver todo

Adhesive strip on the lcd screen replacement?

I replaced the digitizer and in the process the strip on the lcd (it's thicker and seems like it is foam) has been roughed up.... Is there any replacement products I can use? I don't see anything about this anywhere...Also While I have you.... Some areas of the new digitizer act erratic. Where could the issue be?

Contestado! View the answer Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0

Comentarios:

Where did you buy it? Don't buy Amazon...

- de

Agregar un comentario

SALTEA LA ACTUALIZACIÓN

Ahorra reparando con un kit todo en uno.

Compra Kits de Reparación

SALTEA LA ACTUALIZACIÓN

Ahorra reparando con un kit todo en uno.

Compra Kits de Reparación

3 Respuestas

Solución Elegida

This is the foam gasket. It is almost impossible to buy the correct one because nobody seems to care about quality repairs.

Fue útil esta respuesta?

Puntuación 2

Comentarios:

There are quality digitizers with quality adhesive from suppliers like iFixit or Mobile Defenders... Hint sellers online like Amazon is not a good choice, unless you have proven that the seller has quality parts. The black adhesive is best and the clear is "cheap jelly" to say the least! I have perfect seals with the black and constantly coming unsealed with the clear mess... Hope this helps.

- de

Agregar un comentario

if the screen is "ghost touching" Meaning just randomly touching places and acting wierd. 1 of 2 problems.

1. Bad connection

Clean ribbon cable with alcohol.

Reconnect digitizer flex. Reset the device

2. If that doesn't fix it than more than likely you have bad part.

Fue útil esta respuesta?

Puntuación 0

Comentarios:

I actually discovered that the ghost touching is because of an ESD happening between the digitizer and the chassis. Kapton tape along the bottom of the lcd does the trick

- de

hi sean,

the foam gasket u can buy on etradesupply.

i can not give u a link, cause the system will mark it at spam- this already happened.

etradesupply has a warehouse in the US.

i am in switzerland and order from the warehouse in china.

it's the best foam gasket i ever saw, cause it's comeing on a template.

just place the template over the lcd and push a little bit the foam and take it off and thats it.

- de

Agregar un comentario

There are quality digitizers with quality adhesive from suppliers like iFixit or Mobile Defenders... Hint sellers online like Amazon is not a good choice, unless you have proven that the seller has quality parts. The black adhesive is best and the clear is "cheap jelly" to say the least! I have perfect seals with the black and constantly coming unsealed with the clear mess... Hope this helps.

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Añadir tu respuesta

Sean Smith estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 885