Opciones

Were to solder wireless antenna connector?

Hello,

I have an automotive DVR installed on my car.

As you can see on the picture, it has a space for a wireless antenna adapter.

https://www.dropbox.com/s/u912tilpwba8t5...

Unfortunately i have no electronic skills and need some help to figure-out where should I solder this connector into the communication board of my device (See pictures of the board).

https://www.dropbox.com/s/faml6djb3uejy0...

https://www.dropbox.com/s/8tfd4u0wmga1dw...

https://www.dropbox.com/s/igssuyxj6f90to...

I would appreciate very much if someone could help me.

Thanks

Sylvio

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Sí No

Puntuación -1

2 comentarios

This question was migrated from http://meta.ifixit.com/Answers.

7 de ago. de 2013 - de iRobot

Can you give us the make & model of your DVR unit

7 de ago. de 2013 - de Dan

Agregar un comentario

Publicado: 7 de ago. de 2013

Opciones

If you can identify the make & model 1st try to contact them to see if they have an upgrade kit. If not see if you can find out what WiFi PC Card they used on the higher end sister model that will be the unit you will need to get. You won't be able to use anything else as the firmware in the unit will expect this explicit WiFi unit.

Most likely you will also need a firmware update to make it work as well.

Fue útil esta respuesta?

Sí No

Puntuación 0

Agregar un comentario

Auto Accessory

Were to solder wireless antenna connector?

1 Respuesta

Añadir tu respuesta