Saltar al contenido principal

Modelo A1288 / 8, 16 o 32 GB de capacidad

Preguntas 451 Ver todo
Pregunta Cerrada

Replaced digitizer, touch still not working

Alright so I'm relatively experienced at fixing iDevices, but I'm not sure what to do at this point. I got a 2nd Gen iPod Touch from someone a couple years back for cheap because the digitizer was broken, so I replaced it and it worked fine. So I gave it to my brother, and he broke the screen, and for this past Christmas his gift was a screen replacement. It worked great for about a week, and then the touch wouldn't work. So I was thinking the cable came loose, and I took it apart, and as best I could tell it was just fine. After tinkering with it I noticed that the cable was torn - I think I must have torn it without noticing. So I just bought a new one off of eBay, and that digitizer won't work on this iPod either. So if it isn't the digitizer, and on a quick inspection the connector on the logic board looks fine, what could it be? Any guesses or suggestions?

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0
1 comentario

As of this point I haven't made any progress. Any ideas?

- de

Agregar un comentario

1 Respuesta

Solución Elegida

If the touch does not work despite a new digitizer and the connector is okay, no bend broken or corroded pins, the only other thing should be the touch IC I believe that the iPod 2 uses the same as the iPhone. No a who;e lot of schematics or diagrams out for the iPod....

Fue útil esta respuesta?

Puntuación 1
Agregar un comentario
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 679