Saltar al contenido principal

Modelo A1312 / Mediados de 2010 / 3.2 GHz Core i3 o 2.8 y 3.6 GHz Core i5 o 2.93 GHz Core i7, ID iMac11,3

Preguntas 382 Ver todo

Replacing the video synchronisation cable

Hello,

Unfortunatly while tearing down my new iMac (to change the Internal HardDrive) something went wrong (%&#* clumsiness lol) and the 4 pin synchronisation video cable was scratched (which link the 27" screen and the board to left of the alimentation unit).

Does anyone know where I can find some replacement cable ? I've looked everywhere unsuccessfully :-(

Thanks a lot for any response !

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 1
1 comentario

Thanks for your response.. i've looked on the apple site and call a tech center. Unfortunatly degradations due to bad manutention break the warranty as i supposed :-(

I've managed to "fix" the cable but a new one would not be luxury lol

Here again, any clue would be very helpfull, thanks !

- de

Agregar un comentario

4 Respuestas

Solución Elegida

This machine was still under warranty. Parts will be very hard to find as it is so new. It might still be covered if it was in the original condition.

Fue útil esta respuesta?

Puntuación 2
Agregar un comentario

Apple's part number for the VSYNC cable for this model is 922-9161, hope this helps.

Chris

Fue útil esta respuesta?

Puntuación 2
Agregar un comentario

I "googled" it but no relevant result :-( I'll keep the part N° however and thanks for the intell ;-)

Fue útil esta respuesta?

Puntuación 1
Agregar un comentario

Applecomponents 64NE FARRAGUT ST. PORTLAND OR. 97211-2206 . I purchased this cable from them.Best of luck!

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Añadir tu respuesta

fpeliss estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 1

Todo El Tiempo: 2,122