during carpenter operation i used my camera to film any sequences of the job,the air was a little bit contaminated with wood powder and dust.
After use i noticed a thin layer of dust and some chips inside lenses that compromize photo quality.
Unable to clean.
Es esta una buena pregunta?
Rep: 782.4mil
1.1mil
893
2.3mil
marco, there are really only 2 ways of doing it. One is to completely disassemble your lens and to clean the components. This is very involved, requires soldering and working with very small and intricate placed parts. The other way is to replace the lens. Check under the Device page right here and scroll all the way to the bottom. Download the service manual from there ;-) (Merry Christmas) page 28 and on will show you the procedure. Hope this helps, good luck.
Fue útil esta respuesta?
Ultimas 24 horas: 0
Ultimos 7 días: 1
Ultimos 30 días: 4
Todo El Tiempo: 2,211
