Rep: 71
5
9
When screw sizes are stated in the guides, does the mm(length) include screw-top cap depth? Are shank widths?
Example: LCD REPLACE:
Step 5 — Upper Case ¶
*
Remove the following 3 screws:
o
One 11 mm Phillips #00 in the middle of the case.
o
Two 14.5 mm Phillips #00.
Es esta una buena pregunta?
Rep: 782.4mil
1.1mil
893
2.3mil
Crocdog, that is a question, which only the person who wrote the guide, can answer. Habitually, when measuring any kind of bolt, only the length of the thread part is measured, not the bolt head. Hope this helps, good luck.
Fue útil esta respuesta?
Bolts? I thought they were screws.
Hioldturkey, I got two answers. You say top IS included. machead3 says otherwise. Threads only. Thanx for your response. it helps.
I can't figure out how to 'accept & return' on this page. crocdog
Crocdog, what I said is, that only the person who wrote the guide, can answer it for sure. We do not know how the person measured it. It is not common to measure the bolt head in the length of the screw.
Rep: 116.3mil
66
68
359
Yes - see: fastener measuring the # is the driver size. That number, such as "Phillips #00" or "Torx T5" are not characterized by a linear dimension, but are for the most part arbitrary designations in the same sense as a "Size 8" shoe or dress.
If this answer was helpful please remember to return and mark it Accepted.
Fue útil esta respuesta?
Hi Machead, I got two answers. You say top IS included.
Oldturkey03 says otherwise. Threads only.
Thanx for your response. it helps.
I can't figure out how to 'accept & return' on this page.
crocdog
Ultimas 24 horas: 0
Ultimos 7 días: 0
Ultimos 30 días: 2
Todo El Tiempo: 3,439
