Introducción

Guide for removing the power board in a Sony PSP-3000

Place the PSP face down and locate the battery cover on the left side of the device. Lift and remove the battery cover to reveal the battery. Remove the battery.
  • Place the PSP face down and locate the battery cover on the left side of the device.

  • Lift and remove the battery cover to reveal the battery.

  • Remove the battery.

Agregar Comentario

Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.
  • Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.

Agregar Comentario

Unscrew all four screws from the back of the PSP with the Phillips #00 Screwdriver. Two are located behind the battery's warranty sticker.
  • Unscrew all four screws from the back of the PSP with the Phillips #00 Screwdriver.

    • Two are located behind the battery's warranty sticker.

    • Two are located on the right side of the PSP.

Agregar Comentario

Next, unscrew the two screws located at the top of the PSP.
  • Next, unscrew the two screws located at the top of the PSP.

Agregar Comentario

Then, remove the single screw from the bottom edge of the PSP (which is positioned next to the barcode).
  • Then, remove the single screw from the bottom edge of the PSP (which is positioned next to the barcode).

Agregar Comentario

Kits de Mac RAM
Acelera tu Mac. Maximiza su memoria.
Kits de Mac RAM
Obtén más memoria para tu Mac.
Slide the spudger in between the outer casing of the PSP, beginning at the "R" shoulder button, and gently pry off the casing.
 Remove the front casing completely.
  • Slide the spudger in between the outer casing of the PSP, beginning at the "R" shoulder button, and gently pry off the casing.


  • Remove the front casing completely.

Agregar Comentario

Push the homebar to the right to release the tab located on the right side of the LCD screen.
  • Push the homebar to the right to release the tab located on the right side of the LCD screen.

  • DO NOT completely remove the homebar, as it is still connected by ribbon cables.

Agregar Comentario

Slowly lift the LCD screen off the PSP starting at the top edge corner. Again, the LCD screen is attached by ribbon cables, so do not remove it completely.
  • Slowly lift the LCD screen off the PSP starting at the top edge corner.

  • Again, the LCD screen is attached by ribbon cables, so do not remove it completely.

    • Orientation of PSP is flipped in photo.

Agregar Comentario

Flip the small brown locks on the four ribbon cable connectors up using a spudger or fingernail. Pull all four ribbon cables out.
  • Flip the small brown locks on the four ribbon cable connectors up using a spudger or fingernail.

  • Pull all four ribbon cables out.

  • Now remove the LCD screen and homebar from the PSP.

Agregar Comentario

Remove the metal tab that lies above the LCD screen.
  • Remove the metal tab that lies above the LCD screen.

  • Upon reassembly, make note that the stamped lettering faces down, and the large tab fits just above the motherboard to the right hand side of the left trigger.

Agregar Comentario

Flip the lock and remove the ribbon cable from the power board.
  • Flip the lock and remove the ribbon cable from the power board.

Agregar Comentario

Remove the screw from the power switch board.
  • Remove the screw from the power switch board.

Agregar Comentario

Remove the power switch assembly/board.
  • Remove the power switch assembly/board.

Agregar Comentario

Linea de Meta

mbnewsom

Miembro Desde 28/10/09

2,331 Reputación

11 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 5

Últimos 7 Días: 24

Últimos 30 Días: 102

Todo El Tiempo: 10,837