Repara tus cosas Comunidad Tienda

iPad Mini 3 Wi-Fi Akku austauschen

Aviso: Estás editando una guía de requisitos previos. Cualquier cambio que realices afectará a todas las 3 guías que incluyen este paso.

Volver a la Guía
Inglés
Alemán
Paso 2
iPad Mini 3 Wi-Fi Battery Replacement: paso 0, imagen 1 de 2 iPad Mini 3 Wi-Fi Battery Replacement: paso 0, imagen 2 de 2

  • Throughout the following procedure, you'll be sliding thin plastic cards between the battery and rear case of the iPad to separate the adhesive securing the battery in place. Be careful to keep the cards as flat as possible to avoid bending the battery, which may damage it and cause it to release dangerous chemicals.

  • Flip the iPad back over and insert a plastic card under the battery cell nearest the logic board and right speaker.

  • If you encounter significant resistance, re-heat the iOpener and repeat the previous step to give the adhesive more time to soften.

Während des nachfolgend beschriebenen Verfahrens, wirst du dünne Plastikkarten zwischen Akku und Gehäuse schieben, um den Kleber zu trennen, der den Akku am Gehäuse festhält. Achte darauf, die Karten so flach wie möglich zu halten, und vermeide es, den Akku zu verbiegen. Dies könnte ihn beschädigen und gefährliche Chemikalien frei setzen.

Drehe das iPad um und setze eine Plastikkarte unter die Akkuzelle in der Nähe des Logic Boards und des rechten Lautsprechers.

Wenn du deutlichen Widerstand verspürst, musst du den iOpener nochmals erwärmen und den vorigen Schritt wiederholen, damit dem Kleber mehr Zeit zum Aufweichen bleibt.

-[* icon_caution] Throughout the following procedure, you'll be sliding thin plastic cards between the battery and rear case of the iPad to separate the adhesive securing the battery in place. Be careful to keep the cards as flat as possible to avoid bending the battery, which may damage it and cause it to release dangerous chemicals.
+[* icon_caution] Throughout the following procedure, you'll be sliding thin [product|IF145-101|plastic card]s between the battery and rear case of the iPad to separate the adhesive securing the battery in place. Be careful to keep the cards as flat as possible to avoid bending the battery, which may damage it and cause it to release dangerous chemicals.
[* black] Flip the iPad back over and insert a plastic card under the battery cell nearest the logic board and right speaker.
[* icon_note] If you encounter significant resistance, re-heat the iOpener and repeat the previous step to give the adhesive more time to soften.

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.